what is the operating principle of contactor(power).along
with disection?
- 3 Answers
- 15951 Views
- NASA, Tech Mahindra, I also Faced
- E-Mail Answers
Answer Posted / ashirbad behera
its an electrical device used for supplying controlled
power supply to electrical equipment along with some other
auxilary contact i.e. NO/NC.or simply u can say its a
distant switching device.it has one magnetic coil,when ever
we give control supply to its coil its get energised &
pulls up main contact for supply leads to make electrical
ckt.again we remove control supply to its coil its de-
energise to release contact.
| Is This Answer Correct ? | 24 Yes | 9 No |
Post New Answer View All Answers
will 1050kva DG set withstand for back charge of 16MVA transformer
Can clean earth cable be considered as low current cable
what is meant by motor startup supervision & motor load jam protection ?
When and where resistance earthing is used ? How to calculate the time constant for earth fault
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
what is the transformer rush current?
what is the Pickup/drop off ratio in BCPU relays
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
is IS says that neutral should be brought to switch box. and this one is a recomended practice
what is is the potential diffrence between two phase ?
Why do not we prefer non conventional sources of energy to conventional sources?
Where servomechanism is used?
What is the universal motor?
