If carbon brushes spring tension either loose or tight,
what happen on Motor performance During Full load Operation?
- 5 Answers
- 8479 Views
- Electrex, HP, TATA, I also Faced
- E-Mail Answers
Answer Posted / kalimuddin
if itis loose then create spark b/n slip ring and if it is
tigth (heavily) then there is the possiblity of the damage
of the slip rings due to friction
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
how tto ingress mw in turbine explain.procedure ?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
1sq mm dc powr cable can carry how much dc currnt
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
what is rocking arrangement in arc heating
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
What is the meaning of loop in transformer
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how much winding resistance of 0.75kw to 12.5kw 3ph sqwiralcage induction motor?
What is rotary phase converter?
What is different between resistance grounding system and resistance earthing system?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
how to calculate percentage impedence at 75 deg C at normal tap
