why transmission line 11Kv OR 33KV,66Kv not in 10kv 20kv?
- 43 Answers
- 113890 Views
- A2Z Group, Baiji Power Plant Gas, Electrical, HCL, Kirloskar, Mepco, NEPC, OAMC, UNI, University of Lahore, I also Faced
- E-Mail Answers
Answer Posted / mahesh
due to less current losses will be minimun
and finly get more result
| Is This Answer Correct ? | 1 Yes | 14 No |
Post New Answer View All Answers
what is differnce btwen lll and lllg faults
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
HOW CAN I GET 5CORE HO7 CABLE SIZE IF I HAVE 1800A?
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
what is meant by 3rd hormonics ?
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
Whether 3 phase induction motorwith 100 hp capacity , Amp 160 for which sensitive earth fault relay , type CTUM 15 can be used?
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
which is better to use svc or synchronous condenser why ?
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
What happens if we run alternator on under frequency?
What are the classifications of heating element?
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
Differenciate between circuit wiring and sub main wiring with illustrations
