Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE THUMBRULE FOR FINDING OUT THE CURRENT CAPICITY
OF A COPPER WIRE?? 2.5, 4, 6MM SQUARE ETC...
- 5 Answers
- 13072 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramesh kumar k
No.. No.. Mr. Raju... it is 2A/sq.mm atmost for safe
operation... other wise copper wire will burn out...
so the thumb rule is the current carrying capacity is
double that of area...
| Is This Answer Correct ? | 2 Yes | 8 No |
Post New Answer View All Answers
Give some differences between open loop and closed loop?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Explain cmrr?
difference between crane drive and line drive.
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
what is the thumb rule for determination resistance of resistor?
how to calculate the battery AH
what is the control circuit for operating the clean room air shower
how did i get the competency certificate as electricle supervisor. iam completed my b.tech.but i dnt have any experince, this certificate is required for applyng ongc mangement trainees. what should i do sir please suggested me
any one please tell taht what type questions will be asked in BHEL interview, i am having interview on 24th Dec, please send this to mail pradeepsistam@yahoo.co.in
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
WHAT ARE THE EFFECTS OF SERIES RESONANCE AND PARALLEL RESONANCE ON THE CIRCUITS PARAMETERS?
what is the meaning of 5% droop or 7% droop in AVR?
Do you need any help with FEWA Electrical Supervisor exams?
