IS there any mechanical connection between the field winding
and armature winding of a dc generator?
- 11 Answers
- 13345 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / manojkrishnan
There is no mechanical connection in between field and
armature windings . The winding of the field is wound on the
stator cores while that of the armature is wound on rotor
cores. There must be a narrow gap in between the stator and
rotor cores ( say 2mm ) so as to rotate the rotor freely .
| Is This Answer Correct ? | 24 Yes | 0 No |
Post New Answer View All Answers
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
How much load can take a 16 mm aluminum cable 3 phase
BRIEFLY EXPLAIN THE STORAGE CLASSES AND THEIR TYPES IN C
. What is Electrical Life & Mechanical Life of Circuit Breaker? 2. What is Electrial Life & Mechanical Life of Magnetic Contactor? 3. What is RCD, RCCB & RCBO? 4. What is the Between defferance of RCD, RCCB & RCBO?
What is the instrument to check the rotating diode fuse of alternator in running conditions?
how i calculate the syncrones generator NGR resistance .if we have a 6mw generator line voltage of generator 11kv also line current 393.3 ampere.
what is the range of maximum DOL and SDS can be use for pump and fan application
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
what is DRP panels?
Please define ohm’s law for a.c (alternating current)?
what is interfacing in computer studies?
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
tell me some type of questions throught which i can prepare for exam and do my best
