Answer Posted / rabindra
dcs means distrubuted control system. it handels large
amount of I/O.
| Is This Answer Correct ? | 19 Yes | 5 No |
Post New Answer View All Answers
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Explain the working of rota meter.
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
What is loop1 and loop2 in MTS LT?
how to calibrate load cell
Describe the functions of the Operator Interface including the considerations related to alarming and display layout/configuration/layers.
what is the imbustion control loop
What is the Working principle of Dozing valve?
How is automatic reference junction compensation carried out in temperature recorders?
why would you like to join our company
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
