why secondary of open delta pt (two element pt) centre tap
is earth what happen when this earth is removed
Answer Posted / jun
It is done to limit output voltage during fault or
malfunction for safety reason. At normal condition this
earth connection don't have any function, it is useful only
during the above-stated condition.
Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
What is turn ratio of a transformer?
Define the overload capacity of the motor?
what is under coal gassification?
How can we choose the rating of submersible motors
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
How to Calculate The sag of OPGW in Transmission Line???
What is dynamo?How it works and what is the function of dynamo in a DG.
300m long and 30kw inductive loade 3phase supply how many size cable required
What is an ideal transformer?
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
Can clean earth cable be considered as low current cable
For some transformers we are using solid neutral earthing while some others we are using resistance earthing why ?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
what is difference between earthingpits,earthing grid & earthing mess?