Answer Posted / abdul wajid
Earthing is done for personel and equipment protection
purpose . Earthing provides the conducting path for fault
current through neutral to ground
| Is This Answer Correct ? | 62 Yes | 13 No |
Post New Answer View All Answers
Dear sir, I have completed DECE in the year 1995. I have work experience in HT and LT LINE more than five years. Now i am doing BE in EEE from rajasthan university. After completion of BE,can i apply "C" Licence sir? Please reply.
explain comutator action in detail.thanks
in science exhibition how lamp can blink when you clap near the lamp ? thank you
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
sir, Is their any measuring unit of knoking? please explian?
What is the role of feedback in a closed loop control system?
How does an induction motor start?
high voltage transformer input voltage,current and amps rating..distributed transformer input voltage,current and amps rating...
What is the resistance of the field winding of a d.c. Shunt generator kept low?
What is the source of dependent source ?
Single line diagram for dbb (double bus bar)system.
Why frequency changes due to load variation in power system ? i.e why when load increases frequency decreases?
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
what is the maximim current drawn by 1 phase and three phase welding machine
