what is interlocing and what is the purpose of this?
- 4 Answers
- 6647 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / kishor a thakkar
i have another example.
we have two belts.one is uper and second os down side for
passing urea or cement.
so we must have privide interlock. first is must run
downside then running is uper belt.
if time any down belt side creat problem so uper belt is
not running. and prouducts will not weasteg.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what are factors comes under relay setting (distance relay 7sa52) under OPEN DELTA VTs connection??
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
how is the cable tray designed & how its total length is calculated for an Industrial plant Say for Ex. (500KW Motor Load)
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
Difference between transition and diffusion capacitance
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
Is it possible to connect a safety device in to parallel?
What is transformation ratio what it describes?
How to calculate fault level of 11 KV system
Dear sir, How to calculate 3.5 core pvc aluminium armoured cable meter wise carrying amps rating.Please give the solution with a good example.
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
HOW TO REDUCE POWER PLANT AUXILIARY POWER CONSUMPTION?
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
How to measure size of cable on a given load
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
