what is the formula of knowing the clabe size on any load?
- 1 Answers
- 7852 Views
- JSW, Scan Steel, I also Faced
- E-Mail Answers
Answer Posted / guest
To find the cable size:
1.Decide the load ratings ie., voltage, FL current of the
load.
2.So that P = V*I*PF
3.Now apply ohms law, V=IR.
4.Now we have the resistance, as per the resistance we can
choose the cable. R= (permeability*Length)/Area of C.S
| Is This Answer Correct ? | 14 Yes | 10 No |
Post New Answer View All Answers
is there any phase difference occurs while primary and secondary side mutual induction occurs?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
how the works electronic energy meter?
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
1.4 What is meant by CT knee point voltage and how would you determine it
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
What is meant by bus bar protection?
what are the disadvantages in GIS over AIS
How to convert 2 phase to 3 phase electricpower in induction moter?
what are problems caused by the pdu in rack server
What should be the height of basement according to NBCC code?
what is earthing.how we make it,describe briefly.
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
