Answer Posted / ravi
suppose if DPT is placed below the datum line of the tank.
It will show negative reading. to make the DPT to show 4ma,
we have to do dero elevation, the elevation of value from
negative to 4 ma to be done, so it is called as zero
elevation. in other way DPT is fixed above the datum line,
the value has to suppressed to 4 ma from higher value and
this is called as zero supperssion. its simple to understand
| Is This Answer Correct ? | 21 Yes | 11 No |
Post New Answer View All Answers
what are the different types of Protocols? & their applications.
Decibel.
draw shematic diagram of c/v positioner(smart type)?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
Tr. Wiring for calibration.
How is work 5/2 sov?
How to calibrate Field bus transmitter? procedure ?
what is difference between HOT permit and cold permit
how to measure oxygen which methods are using?
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
selection criteria of control valve? and selection criteria of actuator explain in brief?
What is hp & mp seperator .& what is its working principle ?
why we are using drum level control valve air to close?
