why we avoid parallel operation of diesl generator?
- 4 Answers
- 7996 Views
- I also Faced
- E-Mail Answers
Answer Posted / lokesh ranjith
because in parallel operation when electricity fails all Dg
sets will gets on even if the load is less also
There will be more diesel consumption
if we run the dgsetd solo mode we can give 80% load can get
goog efficiency
| Is This Answer Correct ? | 2 Yes | 20 No |
Post New Answer View All Answers
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
why we not used 11kva as a direct our electrnics component.
th how could we differentiate between armoured copper and armoured aluminium cable what is the basic application? why we prefer the armoured copper as compared to armoured aluminium.
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
how to calculate the settings for shaft ct protn in hydro generators
What are the specifications for conducting earth leakage test as per IEC standard?
what do you mean by plant earthing system.
How to select a contactor? How many types of contactors are available
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
How will you define capacitance?
Describe Non I.S. Earth System and why is it used?
how to set relay setting? and example calculation...
How can we increase fuel-power ratio of any DG set?
what exactly commisioning work does in electrical site work... LT side?..
what is meant by motor startup supervision & motor load jam protection ?
