what is electricial and mechnical interlock.
- 9 Answers
- 64655 Views
- Control Dynamics, EFS, HP, I also Faced
- E-Mail Answers
Answer Posted / smartguy
An Interlock system is one where an action (mechanical) can
only take place once one or more conditions are met.
| Is This Answer Correct ? | 18 Yes | 5 No |
Post New Answer View All Answers
SUTIABLE FOR ohm's law super conductor
how to select size of hardware for linking aluminium busbar is it depend on area of busbar or current flowing through bus bar
what is d check in dg 1500kva
how to calculate the earth fault current
Let me know that how i calculate the alternator sub tranciant reactance and tranciant reactance.
sir i ve applied for hindustan petroleum and power grid india ltd..and the exams on feb 22.can you pls send model papers and tell how to prepare for those.i need to get into any of these for sure.....
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
Write down the design procedure of commutaj.
what is meant by twilight switches 7 where its applicable ?
A low wet bulb temperature indicates
what is the grounding Calculation formula? spouse i want to provide grounding to 3phase 18kw motor or i want to provide ground to 3phase 10kva dry type transformere or you give me any exemple...... Thanks.
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
