I have 3 phase 25kva transformer how can i connect this
transformer to two phase line?
- 2 Answers
- 5324 Views
- I also Faced
- E-Mail Answers
Answer Posted / pozhilan.s
3 phase 25KVA transformer configuration as 3phase 4 wire
system .it convert into 3phase 3wire system it configure to
two phase line other one is reference bath.
| Is This Answer Correct ? | 4 Yes | 6 No |
Post New Answer View All Answers
What is the height of ESMA card?
tell 10 points about indian education and foreign education?
I NEED 2006&2007 RAILWAY RECRUITMENT BOARD,JUNIOR ENGINEER (SIGNAL) Q&ANSWERS,PLEASE SEND TO: kaleelbe@yahoo.com
Which of the listed is NOT a FlexiHopper frequency band? Which of the listed is NOT a FlexiHopper feature?
I am completed BE electronics and communication engineer I have 4 years experience in mainteance dept .am applying for c license is possible...How 2 get c license
What is tunnel diode?
plz give the question about interview to the post JR.Executive (ATC)
What are the maintenances of a PLC ?
How many types of resistor are there in diode?
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI}}} TECHNICAL question papers TO MY EMAIL ID pushpapappu@yahoo.co.in
Draw vi characteristics of pn junction diode.
what is the use for electrical c licence
difference between pre silicon debug and post silicon debug
We are facing the problem of communication failure between seimens drives and ABB DCS. Between drives and DCS on RLM -01 module for communication purpose. We found red blinking i.e error blinking in RLM -o1 module. So we replaced with new one but after one month same problem again came. So again we installed old RLM-01 module. Now also RED blinking is coming but sometimes drives are not tripping. What will be the cause for this problem?
What are the important ic technologies used?
