Answer Posted / rahul
Watt is unit of power,
power can be of two type effective power and apparent power.
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
Exothermic reaction./ endothermic reaction
How to calculate P,I&D value in PID controller ?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
Valve positioner and actuators in detail.
what are the steps I have to deal with?
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
How to check vortex flow meter is in good condition while we do not having calibration setup?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
What are the uses of orifice plates?
Why do we floating DC in DC system.
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
How to calibrate Field bus transmitter? procedure ?
give some question relative instrument fitter?
