WHY FLEXI LINKS ARE USED INBETWEEN GENERATOR TERMINAL
OUTPUT & BUS DUCT CONDUCTOR.
- 3 Answers
- 4908 Views
- I also Faced
- E-Mail Answers
Answer Posted / surender singh
In output of Generator terminal and Bus duct ,we use flexi
links ie no hard connection because to avoid the transfer of
vibration of generator to bus duct.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
How to calculate ant test the burden of Current transformer
What are the various types of rotor used in the alternators?
why you don not show protection and type of isolation in key single line diagram?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.
is IS says that neutral should be brought to switch box. and this one is a recomended practice
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
plz tell me,ht and lt panel terminals in substations explain beiefly
what is charger supervision and control supervision?
how we can set the IDMT relay.
how to find the resistance and gap volatage of the diode??
what is the transformer rush current?
How a capacitor discharge weld power supply works? what is the use of a pulse transformer?
1.4 What is meant by CT knee point voltage and how would you determine it
what is active power & reactive power?
