How do you calculate of power factor, if it is lagging or
leading for unit(1).
- 4 Answers
- 8350 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajkumar
cos(pie)=active power /apparent power..
i.e cos(pie)= KW/KVA
thanks.........
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
can someone explain that how the speed of the protection system affects the fault level calculation?
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
What is polar plot?
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
Why cables and busbar both needed in LT Panels?
What is the test block protection relay if any body know plz explained
what is difference between earthingpits,earthing grid & earthing mess?
What do you mean by distribution transformers?
how you configure motorvision relay (L&T make)from DCS
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
What is Surge Capacitor? Why it is require in Generator Circuit Breaker,inspite of surge arrester?
why we use the 100% and 95% stator earth fault protection for the synchronus generator ?
what is the purpose of high speed earth switch in gas insulated substat
