What are the steps for Testing of 6.6KV HT Panels?
- 5 Answers
- 33037 Views
- BSL, I also Faced
- E-Mail Answers
Answer Posted / rajendran
The type of panel is not mentioned in the question, how
ever following are the general testing steps....
1) Panel allignment
2) control wiring testing
3) Power ccircuit testing
4) Instument transformer testing
5) Beaker testing if any
6) Relays testing in the panel
| Is This Answer Correct ? | 62 Yes | 8 No |
Post New Answer View All Answers
I am apply the AAI. So i want electrical sample question paper in technical with answer my id is vijayjobsmart@gmail.com
design a 3 bit synchronous and asynchronous counter using T- flipflop
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
Define de-sensitivity?
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
what is meant by carrier aided trip protection in transmission line
What is the role of power pack in substation protection system?
how to convert lv line to hv line and viseversa, any losses will occur during this process
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
Why armature rheostat is kept in maximum position?
How many double suspension hardware fittings are required on a double circuit transmission tower?
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
