Answer Posted / gurudutt sharma
Maximum Demand is a Total load end output after losses such
as powerfactor
| Is This Answer Correct ? | 0 Yes | 9 No |
Post New Answer View All Answers
in science exhibition how lamp can blink when you clap near the lamp ? thank you
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
WHAT IS DEGREE OF COMPOUNDING IN D.C MACHINE MEANS? HOW TO READ THE OPERATING CHART FOR ANY ELECTRICAL MACHINES?
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
1. transformer design formula ? 2. how to calculate the primary turns and secondry turns ? 3. core types ? 4. how to find the primary current and secondry current ? 5. how to calculate the stacking factor ? 6. range of fulx density ?
what is meant by class 1 E in electrical power supply?
On 400 amp factory load how kvarh capacitors provide
sir i had plane to do some project with the base of hopkinson test in AC supply its possible
what is differnce btwen lll and lllg faults
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
Explain mechanical rotational system?
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
what is servo motor and how it works?
