why we express the unit of torque in Nm.even though it can
be expressed as Joule ( J )?
- 10 Answers
- 14109 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / dukul trivedi
the eq. of TORQUE = FORCE X RADIUS
& NEWTON & METER are the one of the units of
Force & radius respectively
| Is This Answer Correct ? | 31 Yes | 21 No |
Post New Answer View All Answers
state the law of thermodynamics?
What is the trunk type and crosshead type piston
if the blade height is increased,then how it increases the specific speed of centrifugal pump?
how can we find the discharge pressure of the pump with the use of flow and NPSH?
What is the difference between austenite stabilisers and ferrite stabilisers ?
what shows avribiations related to bearing blocks
what is the use of vacuum balancing valve in CEP
How to start water tube steam boiler
Explain bearing
Hai, iam renjith. my qtn about the calorex heat and cool pump. What is the reason of the above machine is trip on high pressure. r134a gas using in this system. 8 months old. model is calorex propac 90(3 phase). This system has 2 compressor. Both are starting on 13amps after that rise up to around 21 within 1 minute. After will be trip on high pressure. Showing 68 psi in suction side on standby mode. Can i have a solution without delay? Renjith renjithngm@gmail.com
Difference be betwin Fe-500 as per IS 226-1975 & IS 2062-2006
pl. send me jr.engg.model question for rrb malda.
what is the dome assembly
Enumerate some trouble of fuel injection valve
Is the unit and normal value fuel ratio of an average diesel engine?
