. Which command sequence will allow only traffic from
network 185.64.0.0 to enter interface s0?
A. access-list 25 permit 185.64.0.0 255.255.0.0
int s0 ; ip access-list 25 out
B. access-list 25 permit 185.64.0.0 255.255.0.0
int s0 ; ip access-group 25 out
C. access-list 25 permit 185.64.0.0 0.0.255.255
int s0 ; ip access-list 25 in
D. access-list 25 permit 185.64.0.0 0.0.255.255
int s0 ; ip access-group 25 in
Answer Posted / jitendera sinha
D. access-list 25 permit 185.64.0.0 0.0.255.255
int s0 ; ip access-group 25 in
Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is a Window in networking terms?
What is loop back ip in ipv6?
Explain what are partial updates?
Which protocols do periodically updates?
Which command we give on privilege mode for coming back to user execution mode?
Briefly explain the conversion steps in data encapsulation.
Explain the terms unicast, multicast, broadcast and multicast.
What are the two types of transmission technology use in ccna?
On which bas ospf take decision?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
What is BootP?
Hub in star topology or bus topology?
Which mode called privilege mode?
How do you configure a cisco router for routing ipx?
Can you explain static and dynamic tunnels?