Answer Posted / srinivas tulishetti
Yes. Petroleum is the mixture of hydrocarbon.
Crude petroleum is mixture of paraffins, naphthalenes,
aromatics and asphalts, but not of olefins.
Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
What is the significance of the minimum flow required by a pump?
Is there a quick rule-of-thumb to estimate a gas side heat-transfer rate inside the tubes of a shell and tube heat exchanger?
what is the hearth and arch pressure in furnace?
Are there any general rules that should be considered when designing a slurry piping system?
Hi. I have completed my masters in chemical engineering from M S University in year 2008 and now going to do MS Chemical engineering in Lamar University. I am planning to appear for interview in two weeks from now. What are the expected questions from VO regarding masters after masters ? and wat should i expect to give reply ? kindly give your suggestions. Thanks
Under what circumstances are vortex flowmeters the most accurate?
what is mass flow rate of steam of 7 kg/cm2 pressure in 1 inch id. pipe.
what r the question asked in interview of gate,is it related to course?
Are there any general rules for flushing slurry lines?
Explain what are the affinity laws associated with dynamics pumps?
can anyone send me the written test paper of Indian oil corporation ltd. My email id is pratuljakhmola@yahoo.com
After conducting an internet search for ways to reduce energy costs, I found a recipe for whitewashing that is said to reflect sunlight. The recipe calls for 20 pounds hydrated lime to 5 gallons water to 1-quart polyvinyl acetate. What is a good source of polyvinyl acetate that I can buy at a local store?
hi can anyone tell me some technical questions asked in iocl
Is there a handy way to determine if a horizontal pipe is running full if the flow rate is known?
What is load?