What is the working of AVR in AC generators?
- 13 Answers
- 92517 Views
- Navrachana University, I also Faced
- E-Mail Answers
Answer Posted / s.arunkumar
AVR means Automatic Voltage Regulator.
There are different types of excitation in generators, AVR
is used to regulate the voltage applied to the
generator.Because generator draw enoromous power from the
source in order to regulate this AVR is used.
| Is This Answer Correct ? | 44 Yes | 18 No |
Post New Answer View All Answers
What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?
why magnetising curve not start with zero voltage?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What consists of 2 or more thermocouples to be connented series?
WHAT ARE THE DISADTAGES OF SINGLE-WIRE-EARTH-RETURN SYSTEM USED FOR RURAL ELECTRIFICATION?
What was the Dg set radiator and lube oil temperatures trip in ACB
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
What are the types of class b amplifier?
can we use NPT glands in LT panel
When we connect the large capacitor bank in series ?
how did the testing of protection relays done through current injection
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
could anybody able 2 send me jindal steels previous papers fr electrical steam....pls send 2 my id if possible....sirisha.shaik@gmail.com
How to calculat the ratio of HT\LT in energy meter
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
