Answer Posted / silamparasan p.
SlipRing induction motor, because we can get high starting
torque by adding resistor to it's rotor.
We can change the torque as per our requirement.
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
why you don not show protection and type of isolation in key single line diagram?
How can you sized or estimate the ligthning arrester current rating?
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
What is meant by harmonic distortion?
How CFL &T5 tube light glows?
What are PLC leader logic program method
lenz law application and define
1.ZEBRA conductor(large size) 2.KUNDHA conductor( small size ) 3.panther conductor(very small ) 4.lepard conductor (very very small)
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
CBCT selection
How the annunciator works ? How to do its wiring
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
what is the voltage regulation for unity and zero power factor?
