Interested to Buy Any Domain ? << Click Here >> for more details...
what is the surge arrestor?how it operates?what is the
range for it?
- 4 Answers
- 7480 Views
- I also Faced
- E-Mail Answers
Answer Posted / simon
Surge arrester have a fixed value resistor. If any surge is
produced the resistor will conduct the voltage and passed
it into the ground. It has no range limit
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
what happened when we supply a dc current in dc motor?? can it worked properly?
In HI POT test what is reason for applying the AC VOLTS and DC VOLTS in different applications what is the nessesity for this ?
Name two low frequency oscillators?
distribution is maximum done by a)radial b)network c) parallel d)b & c
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
What is miller crystal oscillator? Explain its operation?
what will be the min and max voltage flow from neutral to earth?
Calculate torque developed by the 3-phase, 5 H.P., 4 pole induction motor runs at 1500 rpm A 23 N-m B 21 N-m C 10 N-m D 0 N-m
how freewheeling diode improves the powerfactor
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What are IR values and what it should be for coil and for insulator
