Why HT cable have only 3 core ?
- 10 Answers
- 26591 Views
- Jindal, McDermott, I also Faced
- E-Mail Answers
Answer Posted / silamparasan p.
Basically the HT cable is used for transmission line only
not in distribution line. Because we are using delta
connection (Three phase Three wire system) for transmission
and star connection (Three phase Four four wire system). So
that's why the HT cables have three cores only.
| Is This Answer Correct ? | 58 Yes | 5 No |
Post New Answer View All Answers
How to know the Max. current caring capacity of the cable by its size ?
I am a electrical engg. diploma holder,applied for junior engineer (electrical),Kolkata RRB. Have I to attend all electrical,mechanical&civil portion in written exam.???
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
errection check list for transformer maintenance
why are u join ntpc
are there rmu for 3 transformer?
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
How to decide the size of the capacitor for a single phase induction motor say 2 HP ??
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
Operation carried out in thermal power stations?
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
