Answer Posted / shiva krishna prasad
1. To reduce antenna height
2. To convert low freq signal to high freq
3. multiplexing of many signals through the same channel
4. To reduce noise& interference by modulation (means shifting
the signal to a place whr oise is less)
5. For narrow banding of signals
6. equipment limitation
| Is This Answer Correct ? | 52 Yes | 5 No |
Post New Answer View All Answers
What are the advantages of bjt?
what are the basic courses can be done for ece branch?
Draw the frequency response of DARLINGTON PAIR
can anyone suggest good link for getting study material fordigital logic circuits?
Which type of power plant is more easier to produce electrical power at economical condition?
i need modal Q. paper of junior enjineer for 1/2009 rrb ajmer exam cat no. 11 jell electrical thenkyou
describe the timing circuit of 8085 mpu?
how to charge for Annual Maintanence
How can I understand electronic/electrical panel wiring & drawing?
i want BHEL electronics and communication placement papers.
What is the need for base values?
Define angle and amplitude modulation? What is noise in modulation?
Can anyone send me question papers for section engineer for railways and send me on my id- abhay_jg@yahoo.com
Tell me is there any junction in conductor?
What type of questions are asked in Tetra pak onlinr test
