On what factors the generating voltage depends ?
Generating voltage are (3.3kV, 6.6KV , 11KV, 13.8kV) Why so ?
- 5 Answers
- 11743 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / atreya
generating voltage= (P*B*N*Z)/ (60*A)
where,
P= no. of poles of the m/c
B= flux or excitation given
N= speed of rotation
Z= no. of conductors
A= no. of parallel paths for flow of current
(for lap wound m/c s: no. of paths= no. of poles)
(for wave wound m/c s: no. of paths= 2)
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
Difference of induction motor & servo motor ??
can the measured percentage error during calibration of single phase energy meter be negative?
Why does inductive loads consume KVARs?
The power supplied to a 33microF capacitor from a 120V, 60Hz source will be
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.
What is precision of a measurement?
What are the different sign conventions used in electric circuits?
State thevenin’s theorem?
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
What conditions are required for transformer to operate at low frequencies ?
In CTs tan delta point should be earthed , what is the reason behind it?
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
my diploma certificate in my higher education college
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
