Answer Posted / zia uddin
As we know product of voltage and current on primary side
is equel to product of voltage and current to the second
side it meas their product is same
on high voltage side current is less and on low voltage
side current is high....therefor to minimise spark we
always use high voltage side for tapchanger.
| Is This Answer Correct ? | 36 Yes | 1 No |
Post New Answer View All Answers
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
Advantage of LT panel vs HT panel
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
What do you mean by Frame 5 Gas Turbine as well as Mark II.
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
what is the maximim current drawn by 1 phase and three phase welding machine
i have some screw comprressor with 630kw power,i have established them with simple star to delta circuit,by the way there is so much inertia when the screw comprressors start, can you offer me contactors power with 400vac or any cataluge to choose the contactors
How to design harmonic filter at the project stage without nowing the harmonics levels
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
what are the basic insulation levels & what its Unit
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
