Answer Posted / saleem
Normoly in HT side 11kv voltsge and less current will be
there But in LT side voltage will be less and current was
very high.So if we change tappings in LT side a huge spork
will come.to avoid this OLTC has to be fixed in HT side
only.
| Is This Answer Correct ? | 59 Yes | 2 No |
Post New Answer View All Answers
SUTIABLE FOR ohm's law super conductor
What is meant by impedance? difference between high & low impedance ?
How out of step protection relay works?
What is the importance of counter based plan & how is it scheduled?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
What is the disadventage of gland earthing(power cable) if any. ?
is ac supply can store
What are linear and non-linear systems?
What is meant by system?
there are cam operated switches - why we call cam operated , What is cam ?
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
why dc is used in control circuits for MV & LV switchgeras instead of ac
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
PLZ EXPLIN ABOUT CLASS PS CLASS CT .WHY THEY R DESINED AND FOR WHAT PURPOSE?WHY OTHER CT CANT BE USED AS PS CLASS CT? EXPLAIN IN SIMPLE LAUNGAGE IF POSSIBLE PLZ GIVE CIRCIT DIAGRAM?EMAIL-RAJ_SINGH_0376@SIFY.COM
how to calculate the capacitor to maintain power factor?
