According to general circuit diagram of 1-Phase t/f , why
the primary is not get short circuited ,even though the
supply terminals both are directly connected through
primary winding?
Answer Posted / veeru
there is a chance of short circuit even vith
resistance,inductance.
The reason is that just the current flows through tye
path "v+,primary wdng,v-".
just path should be closed to flow current.It is the
basic rule in electricity..
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
briefly explain principle of resistance welding
The simple way of finding the leakage quantity and % in compressed air distribution system
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
what is the difference between droop mode and ischnorous mode in thermal powerplant?
what is the function of gss in the dg set.
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
What is the tipical Online UPS input voltage for 20 KVA load ( 3 Phase or 1 Phase )? Why ? Explain it...?
What is error of a measurement?
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
How to convert a two phase power into a three phase power in induction machine?
How to calculate the value of earth capacitance in a transmission line.
What do you mean by per capita requirement of electrical energy in india
Define conversion efficiency of a power amplifier.
what is negative d.c. voltage, why this voltage is used in base transciever station.
What is difference between isolator and circuit breaker?