Answer Posted / arockia doss
Reasons Behind :
1. Loose Connection
2. Three phase cut into two phase
3. Winding Failure
4. Mechanical Damage/Overlaod
5. Higher Voltage/Frequency
If its so ,Breaker should get trip. If not it will damage
the motor.
| Is This Answer Correct ? | 17 Yes | 3 No |
Post New Answer View All Answers
what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.
does a DG set has low fault level as compared to that of a transformer.If yes then why.
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
What is a system?
why sometime we get electrical shock while touching the ballon of dish tv connection ? which we should not get.
How we can recongnise the phase displacement of transformer connection between primary & scondary...plzzz explain it with example.........
What is the pro & con of having 11kv & 33kv incoming, and what is the adv & disadv. of converting from 11kv to 33kv.
how to find the voltage's of a transmission line plzz help with pictures i am not able to understand
how to extend relay operating timing in 24V dc relay card (without using Timer )
how solar power plant energy meter multiplication factor
How to calculate the heat load for a electrical room
what happen when power factor of 2 parallely operated transformer become equle?
how many single tension hardware are required on a double circuit transmission tower?
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
What the main causes of transient interruptions on Over-Head Distribution Lines?
