Answer Posted / pugal
to check the no and nc terminals
| Is This Answer Correct ? | 5 Yes | 8 No |
Post New Answer View All Answers
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
What is the effect on Power factor and capacitor when your company load is more than 70 % of welding transformer
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
A jet of fluid strikes a plate What was the force required to counter it?
What is Anemometer used to measure?
HOW WE CHOOSE EARTH'S POTENTIAL AS ZERO V?
1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
how balanced in star delta connection ?
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
what is kondo syatem in eletrical traction
