what is the length of air terminal in lightening arrester
system.
- 1 Answers
- 3941 Views
- I also Faced
- E-Mail Answers
Answer Posted / md. zakir hosen
We know that some of the lightning arrester is long and some
are short but some times capacity is same or more then long
one. its depends on the capacity and internal arrangement of
the LA.
thanking u
http://a2zengineering.blogspot.com/
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
HOW TO REDUCE POWER PLANT AUXILIARY POWER CONSUMPTION?
What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
What is the ideal position cooling fan inside the dc motor?
how oti and wti connections are different from each other?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
how to calculate units consumption for a 12 hp motor /hr.
why do we put a transformer on soak before loading it
I have experienced electrical maintenance HT ,but I completed be ECE ....can I apply c license or not ???? Pls help me friend s...
What is the difference between alternator and generator?
it is in our knowledge tht right plug of supply of residential suppy system is phase n other is neutral...howevr the battery charger of mobile works in both ways...i mean it is not restricted in only one direction.ny of the holder of charger can hav phase .so y is it not lik tht phase of supply must b connected 2 phase of charger...?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
66kv under ground cable how to layaing in ground any special case two ckt r runing
What is dielectric loss?
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
