Answer Posted / md. zakir hosen
UPS means Uninterruptable Power Supply. Its function is to
convert AC power into DC and store in a Battery when AC
supply is interrupted (no electricity, under voltage or over
voltage) then UPS act as a power supply by Inverting DC to
AC from the charged Battery.
thanking u
z_hosen@yaoo.com
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
I am doing apprenticeship training at HT switch yard in NLC. How can i get electrical c license. ??? What r the rules for getting it as an apprentice? ??
What is notching in dc machine?
Why the output of OP-AMP is always less than Vcc?
What is online and offline ups? how does it works?
What safety precaution are to be taken for avoiding electric hazards ?
What is the principal of motor?
What is the significance of integral controller and derivative controller in a pid controller?
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
what is interfacing in computer studies?
How to decide whether A / B / C / D curve type MCB should be used?
HOW TO CALCULATE HV CABLE SIZING?
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
how to calculate transformer turn primary & secondary side 11kv to 420v
