Answer Posted / arun gur
MCB (minature ckt breaker)
contains a bymetalic strip which heats up and bend as
current flows through it. the mechanical switch is operated
after it bends above a perticular angle when current flows
beyond the rated current
| Is This Answer Correct ? | 10 Yes | 4 No |
Post New Answer View All Answers
What are root loci?
how do you choose the cable size as per amps rating & the voltage drop for the same.
define reflection method?
Who many reason of ignition fail ?
What is Antipumping Function & If we have C.T how we find the Ratio ?
Difference between ac parallel circuit and ac series circuit?
diff.between servo motor and ac motor
how does the rotating m.m.f is produced in the 3-phase induction motor and how the poles are created in 3-phase induction motor ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
rajha power sector details
I Have 3 Phase 10 KW AC Alternator i found one phase weak, so what will be the reason & what action shouls i take to rectify the same.
what is protection class current transformer.
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
Whether power factor should be high or low? Why?
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
