if u have to give support in 1 km long bridge,where u will
give it & how many?
- 10 Answers
- 13583 Views
- HAL, ISRO, I also Faced
- E-Mail Answers
Answer Posted / karthick
i think first we have to support it like a simply supported
beam.then with that we have to find out the shear forces
acting along the beam.with that we can draw a shear force
diagram.from that we can calculate the maximum bending
moment.again we have to give support to that max bending
moment place
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
can any one pls refer me any sites which have notes regarding Body-in-white(welding fixtures)...pls
What does afbc stand for?
How will you classify sliding contact?
Steps In starting boilers.
What is maximum continuos Rating?
What is the maximum use of magnesium ?
I need BHEL apptitude questions
What are the procedures on how to anneal?
What do you mean by A.CC.?
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
What is base design drawings?
Please tell about the water type h.v.a.c with it's cycle and functions of each parts ?show me how talented u r?
How oxygen can be removed from steel during melting? What are fully killed steels ?
please briefly explain the Discharge process and Formula of Centrifugal Pump
what is an function of air cell bag in air cell conservator
