what is the Auto Mains Failure Panel function in DG?state
its function?
- 3 Answers
- 17646 Views
- I also Faced
- E-Mail Answers
Answer Posted / chandru_williams
The main function of AMF panel is to sense wether the raw
power is avail;able or not . If raw power fails it
immediately starts the auto ON of the DG set
| Is This Answer Correct ? | 31 Yes | 5 No |
Post New Answer View All Answers
What is I to C?
What is frantic effect?
what is the minimum clearance between a 11KV 150KVAR capacitor cell and series reactor.can a series reactor can be mounted in the same structure of the capacitor cells structure
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
What are the advantages of the three-phase motor over single phase motor?
what are factors to be consider to design a HT & LT motor?
how to calculate earth fault relay current and CBCT ratio
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
Discuss the effect of sudden loading of an induction motor
what is the differences between microprocessor and general purpose computer
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
how can decide the current rating of oltc
True or false question. 1.The fuse provide phase and neutral 2.power loss in electrical circuit can take place in (resistance or inductance or capacitance). 3.two phase system each phase has separated by a phase difference of (90 or 180 or 270 or 45). 4.3 phase balanced star connected load neutral current shall be (line current or phase current or zero or unity)
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
