WHY WE CAN GENERATE POWER IN 3PHASE MODE ONLY NOT IN 4 OR 5
PHASE?
- 8 Answers
- 8280 Views
- I also Faced
- E-Mail Answers
Answer Posted / max
the practical reason the vibration machine less in 3 phase
but there is as such no rule to have 3 phase u can have as
many as phase u want but u gen must have that kind of windings
to generate 3 phase
| Is This Answer Correct ? | 2 Yes | 6 No |
Post New Answer View All Answers
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
Explain what is rated speed?
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
Define ampere
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
Why hydropower stations are preferred solution for meeting peak loads in grids?
Earth leakage relay basic knowledge principle
Air refrigeration cycle works on the
Mention how NPN and PNP transistor works?
what is two point starter?
what is the min and max ohmic resistance for the earthing rod installed for lighting poles for street light network
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
700KW 6.6KV slip ring induction motor to use VFD to control the speed
