canu tell me why 4-20 ma and why not this 3-25ma?please
give reason of this value.
- 6 Answers
- 9076 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh mistry
1> Liner Scale
2> Live Zero as a electronics
3> Active signal for pneumatic equipment.
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
Explain working principle of lvdt?
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
what about your moleg in pogrees with company
How flow can be measured with dp?
if my flow is 20000 m3/h than which range of DPT i have to use????
What is difference between radial vibration and axial vibration explain in detail .
Name different types of bourdon tubes.
What is furnace draft control?
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
what is droop in governer ,type of droop ,how it work
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
