when a three phase motor in running condition consumes 2A
in each phase,and if one of the phase gets fails what will
be the consumption in other two phases
- 4 Answers
- 5279 Views
- I also Faced
- E-Mail Answers
Answer Posted / pratheesh
If one of the phase fails when a 3phase induction motor
is running, motor will continue running with a 25
percentage of more current in other 2phases.
If the thermal overload protection is not working
perfectly, the motor winding may burn.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
how load of a turbo generator can be increased
What are the applications of different multistage amplifiers?Plz also write advantages of these amplifiers? Thaaaaaaaaanx
Approach of a cooling tower is the difference between temperatures of what factors?
we have a rewind motor of 2Hp,2800Rpm, 220Volt AC. how can we choose the running capacitor for this motor, any formula for that?
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
The principle of switching circuits for different types of batteries in application of storage systems
What is the RME and explain the full form and what is the RME work?
What is the function of auadag in a cro?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
How dia computation perfomed in cold rolling mills .
please send me the L&T Emb. sys. placement papers and entire details of pattren
