We wish to test 60 Hz systems from a 50 Hz supply. To
acheive frequency conversion, we use a VFD. The VFD powers
40 kVA transformer, which has motor and non-motor loads on
it. Will the transformer work?
- 2 Answers
- 5401 Views
- Suzlon, I also Faced
- E-Mail Answers
Answer Posted / ak
check the voltage it may not similar on vfd output
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What is formula calculation size cable wire ?
What is the purpose of stablization resistor in high impedance bus bar protection
what is the voltage regulation for unity and zero power factor?
Dear Sir I am living in Jaipur Rajasthan now I did complete my b tech degree in electrical engineering in 2012 Sir how I gate certificate of competency for electrical supervisor
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture
what is the difference b/w ATS and HTS?
What is the formula to calculate the rating of a three phase miniature circuit breaker
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
What are root loci?
what is meant by moulded case circuit breaker ?
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
