What is the difference between double compression
Answer Posted / j.i.doddamani
The basic diffeance between single and dobble compression
1. Parts of Double comp
a. Gland body
b. Gland body Nut
c. Cone
d. Cone Ring
e. Neopen Rubber seal.
f. Rubber Washer
i. Check Nut.
2. Single Comp Parts
a. Gland body
b. Gland body Nut
c. Neopen Rubber seal.
d. Rubber Washer
e. Check Nut
f. Flat washer
The Basic differance between Single and Double Comp is
1. In Single comp there no cone and cone ring. The
mechanical support for the cable is only Neopen rubber
seal,When u tighting the cable.
2. In double camp gland the mechanical support to the cable
only cone and cone ring. When doing glanding the cable
arrmour sits on the cone and cone ring act as a lock for
armour.
Is This Answer Correct ? | 44 Yes | 9 No |
Post New Answer View All Answers
Whether should be the oil level in OCTC transfomer? It should be upto winding immersed completely or should be upto tap changer s/w? How it will affect the performance of the transformer. Rating may be 33KVA
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
how to calculate short circuit current for the busbar
explain the mode of metal iranafer in Co,welding
Does the motor power displayed on the Motor name plate is the mechnical power motor delivers or it is consumed power from the system?
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
How we can calculate the life of Lead acid battery
Explain cmrr?
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
diff b/w normal grounding and resistance grounding
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??