What are the technical reasons for soaking transformers for
various times before allowing them to pick load after a
fault ?
Answer Posted / j.kesavan
sorry friend, soaking trs we are using in vsd drives why we
want to reduce the hormonics in power system.
| Is This Answer Correct ? | 0 Yes | 30 No |
Post New Answer View All Answers
i am going to correct power factor of 1600kw induction motor,when i calculate capacitance of capacitor it is three time more in star connection than delta. if motor is star connected which connection i shall adopt for capacitors and reason for adopt this connection
what is transient voltage?
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
Air refrigeration cycle works on the
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
how to select overload-relay for perticular motor 1.for D.O.L. starter 2. for Star-delta starter ????
how to calculate the cable current ratingand and how much of distance the rating will be ok will the distance is incresed what the action we take
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.
Why induction motor is widely used in industry
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
Define what is power quality meter ?
Why line VTG = √3 phase VTG in star? How?