Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vikas
bearing is to support the shafts. at the same time
minimises the friction between those relatively moving
components.
| Is This Answer Correct ? | 17 Yes | 2 No |
Post New Answer View All Answers
What is the cause of pressure drop in a centrifugal
please send me rrb question papers of SE MECHANICAL
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
Tell us how do you discharge your duties in your duty post
How can check gear pitch?
What causes damage to impellers?
what is the use of CW(Circulating water ,clarified water,cooling water),auxiliary cooling water(ACW),auxiliary raw cooling water(ARCW)in thermal power plant.plzz explain the different characteristics of these types of water.
In terms of electrical enhineering, give a detailed explanation of the "earth fault loop path"
What is the difference between newtonian and non-newtonian fluids?
when do we use roller bearing, deep groove ball bearing, angular bearing, sealed bearing, semi sealed bearing, unsealed bearing, anti friction bearing, journal bearing, thrust bearing
I want to apply for Asst.vehicle inspector,i would like to know the requirements and the syllabus.. if any body know that please mai me.. naany4u@rediffmail.com please friends
what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.
In order to derive the torsional formulas what are the assumptions taken?
Why is nitrogen used in welding?
What are the causes of damage to propellers?
