The corona effect is more in
a) summer b) winter c) dry weather d)
humidity weather
Answer Posted / aayush
In Humidity, because air is comparetively more wet and
hence ionizes very fast.
Is This Answer Correct ? | 37 Yes | 2 No |
Post New Answer View All Answers
pls someone send me sample question papers along with the key.thanks in advance
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
how to get bearing & winding temperature of an induction motor?
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
what is the ground fault relay,which purpose it will be use,clearly tell me plz
What current position are you holding in your current company?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
What is self exciting?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
solor panels arrange some angle,panel is flat fitted energy was produced or not why?