Interested to Buy Any Domain ? << Click Here >> for more details...
the power loss in an overloaded line is mainly due to?
a. resistance b. capacitance d. inductance
d. none
- 4 Answers
- 6519 Views
- I also Faced
- E-Mail Answers
Answer Posted / bala
a)resistance
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
what is the voltages using in movie theaters??? why ??why not other??
i am electrical and elctronics engg passed out in 2009 want to attend for reliance placements.plz send me apttitude ,technical and hr question answers to my mail plz. my mail id-kat.bindas@gmail.com
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
why 5kW motor becomes unbalance if its relay trip 1st time and its set value is 7.0 A
Define active filter?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
Where should the lighting arrestor be placed in distribution lines?
what is the correct format to create a resume for interview??
what is the id1 & id2 setting in differential protection relay of CSPC?
If SFU is Switch Fuse Unit, What is the expansion for FSHF in Electrical Engineering?
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
What is the formula to calculate the rating of a three phase air circuit breaker
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
