Answer Posted / vijendra joglekar
Types of sub station:
1)Pole mounted type sub station
(for low rating up to 100 kvA)
2)Outdoar type sub station
(for voltage upto 11kv to 132kv)
3)Indoar type sub station
(for voltage local sub station primary voltage
11kv,secondary voltage 400/440 volts)
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
how to calculate singlephase motor efficiency?
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
Define steady state error.
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
EXPLAIN THE WORKING OF SERIES REACTOR IN HT CAPACITOR BANKS (FOR VOLTAGES & CURRENTS)
Define resonant peak?
can we make a electric generator,which can not use any type of fuel,air,solar,gas,thermal,coal,petrol,etc and able to produce electrical energy (or self electricity generating generator)
What is the type of earth fault protection used in battery? explain.
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
What is the Difference between Ac Drives and Dc Drives? According to application, speed, Torque, cost, Reliability, Construction, Motor etc... Thankyou !!!
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
