what happens if i connect acapacitor to a generator load
- 5 Answers
- 13023 Views
- I also Faced
- E-Mail Answers
Answer Posted / p k ajeshkumar
Connecting a capacitor across a generator always improves
powerfactor,but it will help depends up on the engine
capacity of the alternator,other wise the alternator will
be over loaded due to the extra watts consumed due to the
improvement on pf. Secondly, don't connect a capacitor
across an altenator while it is picking up or without any
other load.
| Is This Answer Correct ? | 12 Yes | 2 No |
Post New Answer View All Answers
Write the force balance equation of m ideal mass element.
How we can calculate the life of Lead acid battery
how solar power plant energy meter multiplication factor
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
What are the specifications for getting approval of Substation?
How may I get the maximum current capacity for a particullar size Alluminum or Copper cable if there is compulsion to use?
What is the Minimum winding resistance of motors ( small & big)? referance range
Mention the disadvantages of low power factor? How can it be improved?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
what is smart grid? why we use it? explain in detals bcoz i want give presentatin from it....
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
