What are thermo couple cables and where they are used.
Answer Posted / tarun tewari
thermocouple cables are basically made of same metals of
which thermocouple is made of.they are coming in market
with limited length,if it is less then we have to connect
cable of same speciffication.They are used to connect upto
temperature transmiter.
Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
Why 3 phase induction motor getting supply in body if one of it's phase is cut
can any tell me why slope 40% and 80% is calculated in differential protection?
How grounding is different than earthings?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
in parallel operation of power transformer why the distance between power transformer and capacitor bank feeder is necessary to know
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
Does the motor power displayed on the Motor name plate is the mechnical power motor delivers or it is consumed power from the system?
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
why the NGR (neutral grounding resistor) always OFF during DG off?
how point on wave controller works.
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
33kv Rated output avilable in market (any where in india)
How cmd is calculated in case of energy neters
how we design a pannel to start 10HP motor with the help of star delta starter?